TeeMark Corporation
1132 Air Park Dr.
Aitkin, MN 56431

Phone:
218-927-2200
Toll Free: 800-428-9900
Fax: 218-927-2333
Email:
Paint Can & Pail Crushers
Aerosol Can Crushers
Drum Crushers and Packers
D&E Foundry Ladles
 
Home About Us
Paint Can & Pail Crushers
Super 6P Series
Super 6PJ-VC Model
Aerosol Can Crushers
Super 200 Model
Super 400 Model
Super 800 Model
Drum Crushers and Panckers
DPC 55 Model
DPC 60 Model
DPC 85 Model
DPC 150 Model
D & E Foundry Ladles
Process Ladles
Transfer and Pouring Ladles
Custon Ladles, Accessories and Fetures
Contact Us
 
 
Crushed Paint Cans

Explosion Proof Paint Can Processor
Super 6 Model – Can, Pail & Filter Crusher

Our Super 6 Model Paint Can Crusher uses 30,000 pounds of force to crush six (6) gallon or smaller containers or filters in preparation for recycling or disposal. Crushing of open paint cans takes place on a grate, allowing liquids to pass through for collection in a drum.

Multi-Purpose Crushing
The Super 6 crushes six-gallon pails and most anything that is smaller. Aerosol cans, oil filters, and a variety of pails, cans and drums can all be crushed by the Super 6 Model.

Crushing Force of 30,000 Pounds
Crushes steel* containers so you can put up to 15 crushed paint cans in the space required for a single whole can.

*These units will also crush and squeeze the contents from plastic containers, but plastic tends to spring back to its original size after crushing.

Liquid Collection Capabilities
Liquids (residual paint, chemicals, etc.) that are squeezed from the crushed containers can be collected in a 55-gallon drum, tote, or a container custom designed for your needs.

Optional Roller Conveyor
A motorized roller conveyor belt may be used to remove full collection drums from the crusher stand area.

Crusher Stand
The professionally designed Crusher Stand provides 41 inches of clearance for a 55-gallon drum on a roller conveyor.

Safe Crushing
The Super 6 Model, like all of TeeMark's compactors, is safe to operate, functioning only when the safety door is closed.


Specifications
Crushing Force: 30,000 pounds
Cycle Time: 12 to 20 seconds
Dimensions: 103-inches tall

Clearance Under Stand: 41 inches
Air Requirement: 8 SCFM of air at 80 psi

 
 
 
© 2011 TeeMark Corporation, Aitkin, MN 56431
 
Designed By Sytek